咨询电话:13699145010
Products产品中心

橡胶体积电阻率测试仪

简要描述:所有测试电压(10V/50V/100/250/500/1000V) 测试时电阻结果直读,免去老式高阻计在不同测试电压下或不同量程时要乘以系数等使用不便的麻烦,使测量超高电阻就如用万用表测量普通电阻样简便。既能测超高电阻又能测微电流

  • 产品型号:
  • 厂商性质:生产厂家
  • 更新时间:2024-01-31
  • 访  问  量:1297

详细介绍

品牌AIRTIMES/中航时代

ZST-121橡胶体积电阻率测试仪

符合标准:
GB/T 1410-2006《 固体绝缘材料体积电阻率和表面电阻率试验方法》
ASTM D257-99《绝缘材料的直流电阻或电导试验方法》
GB/T 10581-2006 《绝缘材料在高温下电阻和电阻率的试验方法》
GB/T 1692-2008 《硫化橡胶 绝缘电阻率的测定》
GB/T 2439-2001《硫化橡胶或热塑性橡胶 导电性能和耗散性能电阻率的测定》
GB/T 12703.4-2010 《纺织品 静电性能的评定 第4部分:电阻率》
GB/T 10064-2006_《测定固体绝缘材料绝缘电阻的试验方法》
GB/T 22042-2008《服装 防静电性能 表面电阻率试验方法》
EN 1149-1-1995 《防护服 静电性能 第1部分表面电阻检验方法和要求》
GB/T 1410-2006《固体绝缘材料体积电阻率和表面电阻率试验方法》(与标准IEC93-1980等效)
FZ/T 64013-2008 《静电植绒毛绒》
SJ/10694-2006《电子产品制造与应用系统防静电检测通用规范》6.1 
一、概述
    本仪器既可测量高电阻,又可测微电流。采用了美国In公司的大规模集成电路,使仪器体积小、重量轻准确度高。数字液晶直接显示电阻值和电流。量限从1×104Ω ~1×1018 Ω,是目前国内测量范围zui宽,准确度zui高的数字超高阻测量仪。电流测量范围为2×10-4 ~1×10-16A。机内测试电压10V/50V/100V/250V/500V/1000V任意可调。本仪器具有精度高、显示迅速、性好稳定、读数方便.     适用于橡胶、塑料、薄膜、地毯、织物及粉体、液体、及固体和膏体形状的各种绝缘材料体积和表面电阻值的测定。
二、主要特点
电阻测量范围宽 1×104Ω ~1×1018Ω
电流测量范围为 2×10-4A ~1×10-16A
体积小、重量轻、准确度高
电阻、电流双显示
性能好稳定、读数方便
所有测试电压(10V/50V/100/250/500/1000V) 测试时电阻结果直读,免去老式高阻计在不同测试电压下或不同量程时要乘以系数等使用不便的麻烦,使测量超高电阻就如用万用表测量普通电阻样简便。既能测超高电阻又能测微电流
三、技术指标
1、电阻测量范围: 0.01×104Ω ~1×1018Ω。
2、电流测量范围为: 2×10-4A~1×10-16A
3、显 示 方 式:数字液晶显示
4、内置测试电压: 10V 、50V、100V、250、500、1000V
5、基本准确度:1% (*注)
6、使用环境: 温度:0℃~40℃,相对湿度<80%
7、机内测试电压: 10V/50V/100/250/500/1000V 任意切换
8、供电形式: AC 220V,50HZ,功耗约5W
9、仪器尺寸: 285mm× 245mm× 120 mm
10、质量: 约5KG
四、工作原理
    根据欧姆定律,被测电阻Rx等于施加电压V除以通过的电流I。传统的高阻计的工作原理是测量电压V固定,通过测量流过取样电阻的电流I来得到电阻值。从欧姆定律可以看出,由于电流I是与电阻成反比,而不是成正比,所以电阻的显示值是非线性的,即电阻无穷大时,电流为零,即表头的零位处是∞,其附近的刻度非常密,分辨率很低。整个刻度是非线性的。又由于测量不同的电阻时,其电压V也会有些变化,所以普通的高阻计是精度差、分辨率低。
    本仪器是同时测出电阻两端的电压V和流过电阻的电流I,通过内部的大规模集成电路完成电压除以电流的计算,然后把所得到的结果经过A/D转换后以数字显示出电阻值,即便是电阻两端的电压V和流过电阻的电流I是同时变化,其显示的电阻值不象普通高阻计那样因被测电压V的变化或电流I的变而变,所以,即使测量电压、被测量电阻、电源电压等发生变化对其结果影响不大,其测量精度很高(),从理论上讲其误差可以做到零,而实际误差可以做到千分之几或万分之几。
典型应用
1、测量绝缘材料电阻(率)
2、测量防静电材料的电阻及电阻率
3、测量计算机房用活动地板的系统电阻值
4、测量防静电鞋、导电鞋的电阻值
5、光电二极管暗电流测量
6、物理,光学和材料研究
标准配置:
1、测试仪器:1台
2、电源线:1条
3、测量线:3根(屏蔽线、测试接线、接地线)
4、使用说明书:1份
备注:
   本仪器配不同的测量电极(夹具)可以测量不同材料(固体、粉体或液体)的体积电阻率和表面电阻率或电导率,*符合国家标准GB1410-2006固体电工绝缘材料绝缘电阻、体积电阻系数和表面电阻试验方法,ASTM D257 绝缘材料的直流电阻或电导试验方法 等标准要求。

Meet the standard:

GB/T 1410-2006 "solid insulating materials volume resistivity and surface resistivity test method"

DC resistance or conductance of insulating materials test method "ASTM D257-99"

Test method GB/T 10581-2006 "insulation resistance at high temperature and resistivity"

Determination of 1692-2008 vulcanized rubber insulation resistivity of "GB/T"

GB/T 2439-2001 "rubber vulcanized or thermoplastic conductive properties and energy dissipation performance determination of resistivity"

GB/T 12703.4-2010 "textile static performance evaluation of fourth parts: the resistivity"

GB/T 10064-2006_ "determination of solid insulation resistance of insulation materials test method"

GB/T 22042-2008 "garment test methods for the prevention of electrostatic properties of surface resistivity"

EN 1149-1-1995 "protective clothing electrostatic properties of the first part surface resistancetest methods and requirements"

GB/T 1410-2006 "solid insulating materials volume resistivity and surface resistivity (test methods" and the international standard IEC93-1980 equivalent)

FZ/T 64013-2008 "plush" electrostatic flocking

SJ/10694-2006 "electronic product manufacturing and application of anti electrostatic detect*tem general specification" 6.1

One, overview

This instrument can measure high resistance, and micrometer current. Using large scale integrated circuit USA In company, so that the instrument has the advantages of small volume,light weight and high accuracy. Digital LCD display directly the resistance value and the current.Range from 1 * 104 to 1 * 1018 Omega Omega, is currently the most wide measuring range,digital with the highest accuracy of ultra high resistance measuring instrument. Currentmeasuring range of 2 * 10-4 to 1 * 10-16A. The built-in test voltage 10V/50V/100V/250V/500V/1000V adjustable. The instrument has high precision, good stability,showing rapid, convenient reading. All apply to rubber, plastics, film, carpets, fabrics andpowder, liquid, and solid and pasty insulating material shape determination of volume and surface resistance value.

Two, the main features

Resistance of wide measurement range of 1 * 104 ~ 1 * 1018 Omega Omega

Current measuring range of 2 * 10-4A to 1 * 10-16A

Small volume, light weight, high accuracy

Resistance, current double display

Good performance stability, easy reading

All voltage test (10V/50V/100/250/500/1000V) resistance test results when direct reading, fromold high resistance meter in different test voltage or different range should be multiplied by the coefficient etc. use inconvenience trouble, ultra high resistance as measured with a multimetercommon resistance like simple measurements enable. Not only can measure high resistanceand current super micrometer

Three, technical indicators

1, resistance measuring range: 0.01 * 104 to 1 * 1018 Omega omega.

2, the current measuring range: 2 * 10-4A to 1 * 10-16A

3, the display mode: Digital LCD display

Built in 4, the test voltage: 10V, 50V, 100V, 250, 500, 1000V

5, basic accuracy: 1% (note)

6, the use of the environment: temperature 0 to 40 DEG C, relative humidity <80%

7, the built-in test voltage: 10V/50V/100/250/500/1000V arbitrary switching

8, the power supply form: AC 220V, 50HZ, power consumption is about 5W

9, the instrument size: 285mm x 245mm x 120 mm

10, quality: about 5KG

Four, the principle of work

According to Ohm's law, the resistance being measured Rx is equal to the applied voltagedivided by current V by I. The working principle of the high resistance meter is the traditionalmeasuring voltage V fixed, by measuring the current flowing through the sampling resistor I toobtain the resistance value. From Ohm's law can be seen as the current I is inversely proportional to the resistance, but not proportional, so is nonlinear resistive display value, i.e.,infinite resistance, current is zero, i.e. zero at the header is infinity, scale near the very dense,with a low resolution. The scale is nonlinear. Because the resistance measurement of differentvoltage, the V will also be some changes, so the high resistance of ordinary gauge is poor accuracy and low resolution.

This instrument is the current flowing through the resistor V and a voltage across the resistor Imeasured at the same time, the large scale integrated circuit internal to complete the calculation of voltage divided by current, then put the results obtained after A/D conversion to digital displayresistance, even current voltage V and the flow resistance at both ends of the I is changed at the same time. The resistance of the display value is not like an ordinary high resistance meteras the voltage to be measured changes in V or I current change and change, so, even if themeasure voltage, measure resistance, power supply voltage change has little influence on theresults, the measuring accuracy is very high (patent), theoretically the error can be to achieve zero, while the actual error can do a few thousandths or very few.

Typical applications

Insulation resistance 1, measurement (rate)

2, measurement of anti electrostatic material resistance and resistivity

3, measurement of computer room with movable floor system resistance value

Resistance of 4, measurement of anti-static shoes, conductive shoes value

5, photoelectric diode dark current measurement

6, physics, optics and material research

Standard configuration:

1, test equipment: 1 sets

2, the power line: 1

3, measuring line: 3 (shielding wire, test wiring, grounding wire)

4, instructions for use: 1

Note:

     The apparatus with different measuring electrode (fixture) can measure different materials(solid, powder or liquid) of the volume resistivity and surface resistivity or conductivity, fully meet the national standard GB1410 - 2006 solid electrical insulation insulation resistance, volume resistivity and surface resistance test method of material, ASTM D257, DC resistance or conductance of insulating materials test methods the standard requirements.

产品咨询

留言框

  • 产品:

  • 您的单位:

  • 您的姓名:

  • 联系电话:

  • 常用邮箱:

  • 省份:

  • 详细地址:

  • 补充说明:

  • 验证码:

    请输入计算结果(填写阿拉伯数字),如:三加四=7
北京中航时代仪器设备有限公司
  • 联系人:石磊
  • 地址:北京市房山区经济技术开发区1号
  • 邮箱:zhsdyq@163.com
  • 传真:86-010-80224846
关注我们

欢迎您关注我们的微信公众号了解更多信息

扫一扫
关注我们
版权所有 © 2024 北京中航时代仪器设备有限公司 All Rights Reserved    备案号:京ICP备14029093号-1    sitemap.xml
管理登陆    技术支持:化工仪器网